10/26/2022 0 Comments Home protector users manual![]() ![]() If active, the siren notifies you about the activation and deactivation the system of the guard mode by the LED and a short sound signal Always - the siren blinks regardless of the state of the security system.Armed - the siren blinks only when alarm is enabled.The volume level is measured 1 m away from the sirenĭuration of the alarm sound: from 3 to 180 seconds Muted - the siren does not sound when the alarm is raised.The tamper mode of the device, which reacts to the detachment of or damage to the body How battery charge is displayed in Ajax apps Offline - the siren is not connected to the hub/range extenderĭisplayed if the siren is working via a radio signal range extenderīattery level of the device.Online - the siren is connected to the hub/range extender.We recommend installing the siren in places with the signal strength of 2-3 barsĬonnection status between the hub/range extender and siren: Signal strength between the hub/range extender and siren. Displayed in 1☌ increment.Īcceptable error between the value in the app and temperature at the installation site: 2–4☌ Measured on the processor and changes gradually. Siren states can be found in the Ajax app: Home protector users manual update#Update of the siren statuses in the list depends on the device inquiry time set in the hub settings, with the default value - 36 seconds. The siren connected to the hub will appear in the list of devices of the hub in the application. To retry the connection, you do not need to turn off the device. You may repeat the connection attempt then. If the connection to the Ajax hub failed, the siren will switch off after 6 seconds. Request for connection to the hub is transmitted for a short time at the time of switching on the device. Switch on the device (by pressing on/off button for 3 seconds).įor the detection and interfacing to occur, the siren should be located within the coverage area of the wireless network of the hub (at a single protected object). If the device was already assigned to another hub, switch off HomeSiren and then perform the standard adding procedure. ![]() Home protector users manual code#
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |